Extended Shaft Pump

GPM-Eliminator™ Extended Shaft Pumps are designed and built with the same Made Tough™ quality and reliability you expect from GPM. Not all applications are designed for submersible pumps. Depending on sump temperature, pH levels, explosion-proof requirements and hydraulic conditions, the wide range of GPM-Eliminator Extended Shaft Pump options are engineered and built to handle your toughest applications.

Available Options:

All stainless steel construction
Explosion-proof
Flows up to 20,000 gpm
Discharge sizes up to 20”
Alternative material options including
- Cast Iron
- Stainless Steel
- High-Chrome
- CD4MCu
Heads up to 500’+

A GPM-Eliminator™ extended shaft pump on a transparent background.

Download a PDF version of the Extended Shaft Pump Overview

Check out a Case Study

Wet-End Configurations

Low Head (LH) Series

Engineered for endurance, GPM’s original Low Head (LH) series slurry wet-end is built to outlast and outperform competing submersible slurry pump designs.

Even Wear (EW) Series

The Even Wear (EW) series is designed to wear evenly over time when pumping thick, heavy tailings. This wet-end is best suited for horizontal and vertical configurations, as it is not equipped with spray holes.

Generation Three (GT) Series

The name says it all—our Generation Three (GT) series is the third generation of the GPM-Eliminator wet-ends, designed for higher flow (GPM) and heads (ft) than the original LH series.